Sony PCV-R553DS Manual do Utilizador descarregar pdf (Página 38)

VAIO Digital Studio™ Reference Manual

Removing the Front Panel

You must remove the front panel to install, remove, or replace internal

components such as a hard drive, optical drive, or diskette drive.

Remove the cover (see “Removing the Cover” on page 22).

Insert a straightened paper clip into the CD-RW optical drive

emergency-eject hole (1 in diagram) and gently push out the tray.

Remove the front plate (2 in diagram) from the tray by pressing up on

the plate with your fingers while pressing down on the tray (near the

plate end) with your thumbs. The front plate snaps off.

Adjust the tray such that it extends out about two inches.

✍

If the tray does not push out, an alternate method is to connect the power cable to the

unit, press the power-on button on the front, then press the eject button on the CD-RW

drive. Then disconnect the power cable from the unit.

✍

If you mistakenly pushed the tray back in all the way, repeat step 2 until the tray extends

out about two inches.

KY0092.VSD

Front plate

Emergency-eject hole

Tray

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 121 122

Sem comentários

Sony PCV-R553DS Manual do Utilizador Página 38