Sony HT-NT3 Manual do Utilizador descarregar pdf (Página 45)

45

GB

HT-NT3

4-559-516-15(1)

D:\NORM'S JOB\SONY HA\SO150038\HT-NT3 (PMRF 06)\4559516151_GB

(CEK)\070ADD.fm

masterpage:

Right

Additional Information

 Make sure that the USB device is

securely connected to the (USB)

port.

 Check if the USB device or a cable is

damaged.

 Check if the USB device is on.

 If the USB device is connected via a

USB hub, disconnect it and connect

the USB device directly to the Bar

Speaker.

The [Control for HDMI] function does

not work (“BRAVIA” Sync).

 Check the HDMI connection (refer

to Step 1 in the supplied Startup

Guide).

 Check that [Control for HDMI] is set

to [On] (page 26).

 If you change the HDMI connection,

turn the system off and on again.

 If power failure occurs, set [Control

for HDMI] to [Off], then set [Control

for HDMI] to [On] (page 26).

 Check the following and refer to the

operating instructions supplied with

the device.

 The connected device is

compatible with the [Control for

HDMI] function.

 The connected device’s setting

for the [Control for HDMI] function

is correct.

 If you connect/disconnect the AC

power cord (mains lead), wait more

than 15 seconds before operating

the system.

 If you connect the audio output of

video device with the system, using

a cable other than an HDMI cable,

no sound may be output because

of “BRAVIA” Sync. In such a case,

set [Control for HDMI] to [Off]

(page 26) or connect the cable from

the audio output jack of the video

device directly to the TV.

 The types and number of devices

that can be controlled by the

“BRAVIA” Sync feature are

restricted by the HDMI CEC

standard as follows:

 Recording devices (Blu-ray Disc™

recorders, DVD recorders, etc.): up

to 3 devices

 Playback devices (Blu-ray Disc™

players, DVD players, etc.): up to

3 devices (including this system)

 Tuner-related devices: up to

4 devices

 Audio system (receiver/

headphones): up to 1 device

(including this system)

The system cannot connect to the

network.

 Check the network connection

(page 15) and the network settings

(page 27).

You cannot connect your PC to the

Internet after [Wi-Fi Protected Setup

(WPS)] is performed.

 The wireless settings of the router

may change automatically if you

use the Wi-Fi Protected Setup

function before adjusting the

settings of the router. In this case,

change the wireless settings of your

PC accordingly.

The system cannot connect to the

network or the network connection is

unstable.

 Check if the wireless LAN router is

on.

 Check the network connection

(page 15) and the network settings

(page 27).

“BRAVIA” Sync ([Control for

HDMI])

Network connection

Wireless LAN connection

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 63 64

Comentários a estes Manuais

Sem comentários