Sony STR-DN840 Manual do Utilizador descarregar pdf (Página 108)

108

US

• The signal strength of the stations is

too weak with automatic tuning. Use

direct tuning.

• No stations have been preset or the

preset stations have been cleared

(when tuning by scanning preset

stations is used). Preset the stations

(page 47).

• Press AMP, then press DISPLAY

repeatedly on the remote control so

that the frequency appears on the

display panel.

RDS does not work.

• Make sure that you are tuned to an

FM RDS station.

• Select a stronger FM station.

• The station you tuned to is not

transmitting the RDS signal or the

signal strength is weak.

The RDS information that you want

does not appear.

• The service may be temporarily out of

order. Contact the radio station and

find out whether they actually provide

the service in question.

The sound is distorted.

• Press 2 – on the remote control

repeatedly.

• Set the “EQ” setting of the iPod/

iPhone to “Off” or “Flat”.

There is no sound from the iPod/

iPhone.

• Disconnect the iPod/iPhone and

connect the iPod/iPhone again.

The iPod/iPhone cannot be charged.

• Check that the receiver is turned on.

• Make sure the iPod/iPhone is

connected firmly.

The iPod/iPhone cannot be operated.

• Check that you have removed the

protect case of the iPod/iPhone.

• Depending on the contents of the iPod/

iPhone, it may take time to start

playback.

• Turn off the receiver, then disconnect

the iPod/iPhone. Turn on the receiver

again and reconnect the iPod/iPhone.

• You are using an unsupported iPod/

iPhone. See “Compatible iPod/iPhone

models” (page 41) for the supported

device types.

The ringtones volume of the iPhone

does not change.

• Adjust the ring volume using the

controls on the iPhone.

Are you using a supported USB

device?

• If you connect an unsupported USB

device, the following problems may

occur. See “Compatible USB devices”

(page 43) for the supported device

types.

– The USB device is not recognized.

– File or folder names are not

displayed on this receiver.

– Playback is not possible.

– The sound skips.

– There is noise.

– A distorted sound is output.

There is noise, skipping, or distorted

sound.

• Turn off the receiver and reconnect the

USB device, then turn on the receiver.

• The music data itself contains noise, or

the sound is distorted.

The USB device is not recognized.

• Turn off the receiver, then disconnect

the USB device. Turn on the receiver

again and reconnect the USB device.

• Connect the supported USB device

(page 43).

iPod/iPhone

USB device

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 123 124

Comentários a estes Manuais

Sem comentários