Sony STR-DN840 Manual do Utilizador descarregar pdf (Página 109)

109

GB

Additional Information

• The receiver is not selected as the

remote speaker on the iOS device.

Select the receiver as the network

speaker.

You cannot connect the receiver to a

service.

• Make sure that the wireless LAN

router/access point is turned on.

• Check the network status. See

“Information” (page 90), then select

“Physical Connection” in step 2. If

“Connection Fail” appears, set up the

network connection again (page 55).

• When the system is connected to the

wireless network, move the receiver

and the wireless LAN router/access

point closer to each other.

• If your contract with your Internet

provider limits Internet connection to

one device at a time, this device will

not be able to access the Internet when

another device is already connected.

Consult your carrier or service

provider.

The sound skips.

• The bandwidth of your wireless LAN

may be too low. Move the receiver and

the wireless LAN router/access point

closer to each other, without any

obstacles between.

The Control for HDMI function does not

work.

• Check the HDMI connection

(page 24).

• Make sure “Control for HDMI” is set

to “On” in HDMI Settings menu

(page 88).

• Make sure the connected equipment is

compatible with the Control for HDMI

function.

• Check the Control for HDMI settings

on the connected equipment. Refer to

the operating instructions of the

connected equipment.

• If you unplug the HDMI cable or

change the connection, repeat the

procedures of “Preparing for the

“BRAVIA” Sync” (page 74).

• When “Control for HDMI” is set to

“Off”, the “BRAVIA” Sync does not

work properly, even if the equipment

is connected to the HDMI IN jack.

• The types and the number of

equipment which can be controlled by

the “BRAVIA” Sync are restricted in

the HDMI CEC standard as follows.

– Recording equipment (Blu-ray Disc

recorder, DVD recorder, etc.): up to

3 equipment

– Playback equipment (Blu-ray Disc

player, DVD player, etc.): up to 3

equipment

– Tuner-related equipment: up to 4

equipment

– AV receiver (audio system): up to 1

equipment

The remote control does not function.

• Point the remote control at the remote

control sensor on the receiver (page 9).

• Remove any obstacles in the path

between the remote control and the

receiver.

• Replace all the batteries in the remote

control with new ones, if they are

weak.

• Make sure you select the correct input

on the remote control.

SEN

“BRAVIA” Sync (Control

for HDMI)

Remote control

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 119 120

Comentários a estes Manuais

Sem comentários