Sony STR-DN840 Manual do Utilizador descarregar pdf (Página 99)

99

GB

Additional Information

On placement

• Place the receiver in a location with

adequate ventilation to prevent heat

buildup and prolong the life of the

receiver.

• Do not place the receiver near heat

sources, or in a place subject to direct

sunlight, excessive dust, or mechanical

shock.

• Do not place anything on top of the

cabinet that might block the ventilation

holes and cause malfunctions.

• Do not place the receiver near equipment

such as a TV, VCR, or tape deck. (If the

receiver is being used in combination

with a TV, VCR, or tape deck, and is

placed too close to that equipment, noise

may result, and picture quality may

suffer. This is especially likely when

using an indoor antenna (aerial).

Therefore, we recommend using an

outdoor antenna (aerial).)

• Use caution when placing the receiver on

surfaces that have been specially treated

(with wax, oil, polish, etc.) as staining or

discoloration of the surface may result.

On operation

Before connecting other equipment, be sure

to turn off and unplug the receiver.

On cleaning

Clean the cabinet, panel, and controls with

a soft cloth slightly moistened with a mild

detergent solution. Do not use any type of

abrasive pad, scouring powder, or solvent,

such as alcohol or benzine.

Troubleshooting

If you experience any of the following

difficulties while using the receiver, use

this troubleshooting guide to help you

remedy the problem. Should any problem

persist, consult your nearest Sony dealer.

Note that if service personnel changes

some parts during repair, these parts may

be retained.

The receiver is turned off

automatically.

• “Auto Standby” is set to “On”

(page 91).

• The Sleep Timer function is working

(page 14).

• “PROTECTOR” is working

(page 110).

The ?/1 (on/standby) indicator flashes

in quick succession.

• The software update has error. Unplug

the power cord, and then plug in the

power cord again. The receiver will try

to update the software. If the indicator

continues to flash in quick succession,

contact your nearest Sony dealer.

No image appears on the TV.

• Select the appropriate input using the

input buttons.

• Set your TV to the appropriate input

mode.

• Move your audio equipment away

from the TV.

• Make sure that cables are correctly and

securely connected to equipment.

Power

Image

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 119 120

Comentários a estes Manuais

Sem comentários